wagon fettle
#2050
Scooby Regular
#2057
Scooby Regular
Thread Starter
iTrader: (41)
Join Date: Nov 2003
Location: in the woods...........555 Wagon Sqn
Posts: 13,350
Received 55 Likes
on
42 Posts
Got some time last night; decided to cut the fuel line down further to get some nice straight bits for the -AN conversion. This ment removing the wiper motor...which in turn ment removing the scuttle panel and wipers, so ended io destroying all my new scuttle panel clips
Loads of room!
Far easier removing the protection from the fuel lines and installing the connectors with the straight run.
Capped off for now...as I have a new job;
...clean this minger up. @silverscoobysport Si any tips?
Loads of room!
Far easier removing the protection from the fuel lines and installing the connectors with the straight run.
Capped off for now...as I have a new job;
...clean this minger up. @silverscoobysport Si any tips?
Last edited by trails; 07 February 2017 at 07:58 AM.
#2058
Unmapped 12.4s @ 105
iTrader: (29)
Join Date: Apr 2005
Location: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Posts: 11,776
Likes: 0
Received 4 Likes
on
4 Posts
Adding an @ before someone's username doesn't tag them, you muppet!
Banny's missus calls him Beefcake or something, I reckon.
You really are a clutz, aren't you!
Banny's missus calls him Beefcake or something, I reckon.
You really are a clutz, aren't you!
#2064
Unmapped 12.4s @ 105
iTrader: (29)
Join Date: Apr 2005
Location: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Posts: 11,776
Likes: 0
Received 4 Likes
on
4 Posts
FFS, tagging fail. And fucking autocorrect bullshit.
This is why I don't bother with SN on my phone.
That and I didn't know about the tagging bollox.
This is why I don't bother with SN on my phone.
That and I didn't know about the tagging bollox.
#2067
Scooby Regular
Thread Starter
iTrader: (41)
Join Date: Nov 2003
Location: in the woods...........555 Wagon Sqn
Posts: 13,350
Received 55 Likes
on
42 Posts
Managed to squeeze in a couple of hours late Sunday after a weekend of working on the house again...
So got the wiper motor back in -twice as I fitted it upside down to begin with, it's been a long weekend
I degreased and cleaned the corner up as the switl pot obscures the chassis leg, so last chance. All holes now grommeted, except three small holes where I'll have to use a tiny dab of silicone. Not sure how much time I'll have after work this week as it's count down to conservatory install, but if I do it'll be getting the fuel filter and 044 fitted on the turret.
So got the wiper motor back in -twice as I fitted it upside down to begin with, it's been a long weekend
I degreased and cleaned the corner up as the switl pot obscures the chassis leg, so last chance. All holes now grommeted, except three small holes where I'll have to use a tiny dab of silicone. Not sure how much time I'll have after work this week as it's count down to conservatory install, but if I do it'll be getting the fuel filter and 044 fitted on the turret.