powder coating front mount
#31
Former Sponsor
iTrader: (48)
Frayz : Thanks for the information and the useful Autospeed article.
I find these very interesting but must have missed that one.
My APS FMIC is on the STi 6 Wagon and I think it is anodised. I bought a batch of five of these about six years ago. At some point in the future I am going to put on the slightly smaller Hybrid GT tube and fin as I believe that will perform better but I have to gather a few more bits of information first.
I find these very interesting but must have missed that one.
My APS FMIC is on the STi 6 Wagon and I think it is anodised. I bought a batch of five of these about six years ago. At some point in the future I am going to put on the slightly smaller Hybrid GT tube and fin as I believe that will perform better but I have to gather a few more bits of information first.
#32
Former Sponsor
iTrader: (48)
TMIC located on STi 3. The moped exhaust section was used to remotely mount the BOV which was still recirculating but now dispensed with.
Note the inverted relocated ICV.
You can also see two temperature senders, one for the Simtek ECU and the other for monitoring ACT.
Last edited by harvey; 29 June 2008 at 01:16 PM.
#34
Former Sponsor
iTrader: (48)
Air Charge Temperature guages.
The installation with two guages allows monitoring of temperatures at the throttle body and the second guage can be used to measure temperatures to the intercooler, from the intercooler or any other chosen location.
Much the same was done with two identical pressure guages to measure the pressure drop on both top mount and front mount intercoolers.
#37
412/425 of forged love
Thread Starter
iTrader: (12)
Join Date: Jan 2008
Location: www.surreyscoobies.com
Posts: 4,238
Likes: 0
Received 0 Likes
on
0 Posts
just an update on this. got front mount fitted. not finished as ive got my new fog covers on order to tidy her up but im happy with the result
#38
#42
412/425 of forged love
Thread Starter
iTrader: (12)
Join Date: Jan 2008
Location: www.surreyscoobies.com
Posts: 4,238
Likes: 0
Received 0 Likes
on
0 Posts
kept them on for now as not sure if im going to put the mesh back on, without these bits it cant be done.
still a work in process mate and didnt want to remove incase in 2 weeks i change my mind.
wont stay if i decide to leave open.
got some fog ducts on order and going to try and get them fabricated in carbon.
still a work in process mate and didnt want to remove incase in 2 weeks i change my mind.
wont stay if i decide to leave open.
got some fog ducts on order and going to try and get them fabricated in carbon.
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM