custom Oil catch can
#64
Scooby Regular
iTrader: (23)
![Default](images/icons/icon1.gif)
If you mean baffled catch cans then yes ellis is.....worth sending him a PM and if you have no joy PM me and i will get in touch with him. ![Thumb](images/smilies/thumb.gif)
I know hes a busy boy though as he was moving home and all sorts so it may be a while until he gets back to you thats if he has internet access sorted at his new place
![Thumb](images/smilies/thumb.gif)
I know hes a busy boy though as he was moving home and all sorts so it may be a while until he gets back to you thats if he has internet access sorted at his new place
![Ponder2](images/smilies/ponder2.gif)
#65
Scooby Regular
Thread Starter
iTrader: (24)
Join Date: May 2009
Posts: 718
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
cheers baly , i am trying to get on as much as i can chaps but am very buisy at mo, anything you wan tho drop me a pm and i will get it sorted for you, chees guys , will try my best to get on each day now to check for any pm's.
#68
Scooby Regular
iTrader: (11)
![Default](images/icons/icon1.gif)
Ellis, I would like to suggest that you up the size of the piping you are using to 14mm ID.
Your add states 3x 10mm pipes, yet i have 8mm id Fuel hose that fits over the pipes.![EEK!](images/smilies/eek.gif)
the small pipes you had on my can were further restricted by the weld. they are not allowing the crankcase to properly vent and as such crankcase pressure is Building up.
Unfortunately for me i Now have low compression in 1 cylinder.
However i would still be happy to buy another one from you with 3 or preferably 4 14mm id pipes.
Derek
Your add states 3x 10mm pipes, yet i have 8mm id Fuel hose that fits over the pipes.
![EEK!](images/smilies/eek.gif)
the small pipes you had on my can were further restricted by the weld. they are not allowing the crankcase to properly vent and as such crankcase pressure is Building up.
Unfortunately for me i Now have low compression in 1 cylinder.
However i would still be happy to buy another one from you with 3 or preferably 4 14mm id pipes.
Derek
#69
Scooby Regular
Thread Starter
iTrader: (24)
Join Date: May 2009
Posts: 718
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
Hi derek, the pipe i use for these should be 10mm od, i can up the size to 14mm, that wouldnt be a problem atall, i just thought the size i was useing was what people wanted as the very first one i was asked to make i was sent a drawing of and it asked for 3x 10mm on top and i hadnt had anyone get back to me saying they here haveing problems, infact i had quite a few pm's saying they had gone on and worked great. I like to be told tho mate if anyone thinks i can do them better so i appriciate your feedback. What welds is it exactly mate that are restricting it further? cheers, ellis
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM