Making Cat5 cables
#1
Scooby Senior
Thread Starter
Join Date: Dec 2004
Location: Passing ...............
Posts: 13,320
Likes: 0
Received 0 Likes
on
0 Posts
Making Cat5 cables
Ok, i followed some diagram after searching google & my cable isnt working.
So can anyone give me some pointers ?
Do i have to bare the ends that i slot into the plug ?
So can anyone give me some pointers ?
Do i have to bare the ends that i slot into the plug ?
#2
Scooby Regular
Join Date: Jul 2006
Location: Swindon, Wilts
Posts: 912
Likes: 0
Received 0 Likes
on
0 Posts
No - you don't bare the ends, just cut them all square and crimp hard!
If they're not all square you may find that some are at the end of the channel and others aren't - which could be the problem... but chances are you've either:
1. Used the wrong wiring diagram - post what you've used.
2. Not crimped hard enough!
This is an accurate guide to doing it: Cat5 Wiring Diagram Just go with the first diagram - standard patch lead (I'm assuming you're not trying to make a cross-over cable?)
If they're not all square you may find that some are at the end of the channel and others aren't - which could be the problem... but chances are you've either:
1. Used the wrong wiring diagram - post what you've used.
2. Not crimped hard enough!
This is an accurate guide to doing it: Cat5 Wiring Diagram Just go with the first diagram - standard patch lead (I'm assuming you're not trying to make a cross-over cable?)
Last edited by Dr.No; 24 September 2007 at 11:12 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM