trickdick

in costco i noticed 5/40 chevron fully synthetic oil at a very reasnoble price
can this be used? has anyone tried it?

[Edited by trickdick - 6/27/2003 3:40:52 PM]

Postman Pat

Last oil (before current change) I had was 5/40 grade. Car sounded very cammy (tappets rattling). I didn't like the sound of it and changed to 10/60 which sounds a lot better.

Pat

StickyMicky

i added sum fully sythetic mobil oil that was 0/40 iirc? might have been 5/40

anyways i came on here and did a search and relise dit was 2 thin, so i had it emoved the next day, still came out clean, engine sounded better when cold with 10/40 mobil in it

Ken E

I have used the chevron oil in a wrx and it was ok. It is the same as any other 5/40 synthetic as far as meeting standards goes. My brother used it for a long time in a primera gt and had no problems. However, you may want to use a thicker oil such as 15/50 if you drive the car hard. Do a search, there are loads of threads about oils. The chevron stuff is probably ok for ordinary driving, as is any equivalent 5/40.

harvey

iTrader: (48)

IMHO 5-40 is too thin and even more so in summer. You will also notice a reduced oil pressure if you have a guage.

Ian D

My 98MY turbo ran on BP visco 5000 5W40 fully synthetic oil for 110,000 miles bofore I bought it (previous owners local dealer service oil). It runs fine and does not use any oil but since i have owned the car (one year and now at 118,000 miles) I have used 10w50 Morris fully synthetic oil based on recommendations that 5W40 is too thin.

Not too convinced that for normal driving 5W40 is not adequate but will run using the recommendations on this forum which are 10W50 or thicker (ie 10W50, 15W50, 10W60) with Mobil 1 motorsport, Castrol RS and Motul often being mentioned.

Make your own mind up...

richiewong

My local dealer uses 10/40 Castrol which is also available from Costco

Charlie H

I changed from Mobil 1 15/40 to Millers Fully synth 5/40 last month as the local motor factor near work was selling 5litres for £19. First thing I noticed was my loud tappett noise that I've had since using Mobil1 (four changes so far) suddenly dissappeared. I don't tend to give the car too much abuse and it is pretty much standard so I don't see any harm in using it again. The car seems to be better from cold as well on this oil.

Absolute Shower

I've been using Comma 5/40 fully syn...changing the oil every 5000 and it's been excellent. No oil is used, only a very small part gets into the induction pipe - blow by which I understand is common on subaru's due to the induction pipe sucking the oil mist out of the crank - and no engine noise, tappets etc.

Car is running 370 bhp according to Scoobysport and it flies. Got an oil pressure gauge and its reading the same with this oil as with the previous oil from the dealers (not sure what that was though)...It's done 23,800 miles now...

X SOOOBY

most dealers use 15/40 semi synthetic if they think it is right i think we should

Johnny50

Have to admit, i put Mobil 0/40 in mine, and it does sound noisy.

But getting it serviced next week, so will be going to Castrol RS 10/60

krazy

x scooby, I was also told by a dealer they use 15/40 semi, but looking up on the products of the manufacturer the said they use the only 15/40 listed was a conventional (mineral) oil?

nellie

I use Motul 300V Power 5/40,fully synthentic in my 325BHP STI7 brilliant stuff not cheap but well worth it.