Any advice on fitting K&N induction
#1
Scooby Regular
Thread Starter
Join Date: Jun 2000
Location: Gloucestershire
Posts: 1,348
Likes: 0
Received 0 Likes
on
0 Posts
Finally plumped for a 57i kit. Which hopefully should arrive tomorrow - which means I get to spend all weekend fitting it!!!!!!!
Is there any special things to look out for or be careful of when fitting?
Matt
Is there any special things to look out for or be careful of when fitting?
Matt
#2
Hi Matt.
Good choice!!!
It's dead easy to fit, at least it was on my MY98. Only took 20 mins. Very straight forward and clear instructions, I'm sure you'll be fine.
One thing though, don't over-tighten the components on each side of the cork 'gasket' they give you. The cork cann break quite easily.
Stef.
Good choice!!!
It's dead easy to fit, at least it was on my MY98. Only took 20 mins. Very straight forward and clear instructions, I'm sure you'll be fine.
One thing though, don't over-tighten the components on each side of the cork 'gasket' they give you. The cork cann break quite easily.
Stef.
Thread
Thread Starter
Forum
Replies
Last Post
oilman
Trader Announcements
15
01 October 2015 11:55 AM
BHPvstorque
Subaru Parts
4
14 September 2015 08:25 PM