Tim,

I tried to fit it today using the instructions you gave me but some of the instructions were a little faint & what I thought was a P must have been an I as I managed to disconnect my rev counter!!!!!

I guess that on the F1 ECU diagram there is no P & instead i'm supposed to cut the AFR labelled wire & use that????? Either that or the FCD but i'm not sure my car's got one as the instructions say "If the vehicle is equiped with an HKS FCD, install the AFR between the FCD & the factory ECU" (Guess not then).

The AFR one is in the far right hand connector & is second from the left on the top row. Is it this one???????

Heeeeeeeeelp.

MAFFA

p.s. it's a MY95

[Edited by MAFFA - 12/6/2001 4:16:15 PM]

 

I've aquired an HKS air/fuel regulator. Does anyone have any difinitive fitting instructions or know where I can get them. Thanks guys

MAFFA

 

http://www.scuderiaciriani.com/rx7/how-to_engine_computer.html

Anything here interest you?

 

From memory you need power and a then to splice the signal wires into the MAF circuit which you can do next to the ECU box in the passenger footwell.

You can then adjust fuel up or down as necessary.

Make sure you get very good connections as you the MAF signal is very sensitive.

If you have a MY99 car I can tell you the right wire you need to splice into on the ECU connector.

Cheers,

Trout

 

Hi Maffa,

If I can find them, I can scan & email you the full fitting instructions that HKS supplied me, I'll have a look tonight

Tim.

[Edited by Tim_K - 11/23/2001 2:47:34 PM]

 

Thanks a lot guys for the help. I would be grateful for the instructions e-mailed to me as that would be even more help.

Trout mine's a MY95.

MAFFA

 

Maffa,

Instructions have been sent!

Tim.

 

Tim,

Thanks for the mail. Unfortunately the attachments weren't there.

MAFFA

 

not got anything to do this time of night eh maf?

 

It's only 12.45am. Hours to go yet b4 I start flakin

MAFFA

 

Have re-sent the mail

Tim.

 

Thanks m8