SUBARU GEARBOXOUTPUT SHAFT PROBLEM
02 July 2008, 07:44 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2008
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
SUBARU GEARBOXOUTPUT SHAFT PROBLEM
Can anyone help? I changed my clutch last week on my uk scooby turbo. i never had a manual but managed ok after trying to remove the drive shafts wrong!! lol
Now my drive shaft moves about alot, how do you adjust the shaft leaving the gearbox to the front drive shafts? It has some sort of part that turns, does it go in or out? its leaking a little bit of oil now from the seals on both sides
Now my drive shaft moves about alot, how do you adjust the shaft leaving the gearbox to the front drive shafts? It has some sort of part that turns, does it go in or out? its leaking a little bit of oil now from the seals on both sides
02 July 2008, 10:49 PM
#2
Scooby Regular
Join Date: Mar 2007
Location: The right side of 30psi
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
The shafts sticking out are part of the front diff, Sounds like you have undone the bearing carriers for the front Diff, ie diff is moving side to side along with the driveshafts.
Obviously they need tightening so stop the diff moving, not sure on how tight though.
Obviously they need tightening so stop the diff moving, not sure on how tight though.
Thread
Thread Starter
Forum
Replies
Last Post
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM