P0171 system too lean(bank 1)
#1
P0171 system too lean(bank 1)
hey lookin for some help with this problem, I was told replacing the front lambda sensor would cure this but it hasn't, I bought a brand new dendo sensor, other things I have done is replace and clean the maf, the problems I have is the car is hesitant on pull and the boost is rough, and dosent reach full boost, any help appreciated thanks
#2
Hi, i had this code recently on my newly brought '53' blob eye sti. The previous owner had fitted an cheapo atmospheric dump valve. As soon as i reverted it back to a standard recirculating valve the code hasnt come back.
May not be of help, but if you have an atmospheric valve fitted, might be worth getting rid of.
Cheers
May not be of help, but if you have an atmospheric valve fitted, might be worth getting rid of.
Cheers
#3
That is a very common fault code and could be lots of things.
A good read on it here.
http://forums.nasioc.com/forums/show...=475620&page=3
Had the same code on my bugeye sti and it went away shortly after i changed the spark plugs.
A couple of the old plugs were not screwed in tight enough which may have been the issue.
A good read on it here.
http://forums.nasioc.com/forums/show...=475620&page=3
Had the same code on my bugeye sti and it went away shortly after i changed the spark plugs.
A couple of the old plugs were not screwed in tight enough which may have been the issue.
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM