Any changes to my planned setup. What u reckon.
#1
Scooby Regular
Thread Starter
Join Date: Dec 2011
Location: birmingham
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Any changes to my planned setup. What u reckon.
Hi guys, just after a few thoughts and comments on anything u might change. After alot of research over the last few weeks and gathering parts here is what im going with.
Ok the car in question is a my00 uk turbo 2000. Ive had one that i owned and tuned before on a td05 but am looking for a good low down torquey setup as i found the td05 a bit laggy.
Ok here is my list then....
New exeedy stock clutch (as the one on it is slipping)
Walbrough
Stock 440 injectors
3 port
Cossy panel filter with resonator left in place
V6 type r top mount with sti hose and stock recirc valve
Vf28 from a v6 sti
A wide mouth decat 3" down pipe tapering to 2.5" heatwrapped up top
Then a ninja 2 2.5" full straight through stainless system
A harvey trick up pipe dei heatwrapped
( the turbo inlet and up pipe i am going to have matched before fitting also)
Mapped on ecutek license once all fitted
Looking for a good solid 300+ b hp and tq with fantastic low down spool hopefully full boost by 3000rpm. Any things you would change/improve. Thanks guys.
Ok the car in question is a my00 uk turbo 2000. Ive had one that i owned and tuned before on a td05 but am looking for a good low down torquey setup as i found the td05 a bit laggy.
Ok here is my list then....
New exeedy stock clutch (as the one on it is slipping)
Walbrough
Stock 440 injectors
3 port
Cossy panel filter with resonator left in place
V6 type r top mount with sti hose and stock recirc valve
Vf28 from a v6 sti
A wide mouth decat 3" down pipe tapering to 2.5" heatwrapped up top
Then a ninja 2 2.5" full straight through stainless system
A harvey trick up pipe dei heatwrapped
( the turbo inlet and up pipe i am going to have matched before fitting also)
Mapped on ecutek license once all fitted
Looking for a good solid 300+ b hp and tq with fantastic low down spool hopefully full boost by 3000rpm. Any things you would change/improve. Thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
30 September 2015 06:29 PM