Removed dash,now car not running right
#1
Thread Starter
Scooby Regular
iTrader: (4)
Joined: Apr 2007
Posts: 432
Likes: 0
From: Guildford,Surrey
Removed dash,now car not running right
Wondered if someone can give me some advice please.
Just removed the dash and now have a few issue's with the car.
Unplugged everything needed to take dash out,inc some extra gauges (oil temp,oil pressure,boost) but never went near the ignition system and Clifford alarm is still flashing and arming/disarming.
But now the car wont start on its own. But it will if I run some jump leads from another car.
Before doing this I could remotely unlock and disarm the battery and start it.
Or if I left it too long i'd turn the key and then have to press the top button on the alarm to release the immobiliser. It used to make a click noise.
It does all this except the click noise now.
Car also now runs lumpy and wants to stall.
Any ideas please?
Thanks.
Just removed the dash and now have a few issue's with the car.
Unplugged everything needed to take dash out,inc some extra gauges (oil temp,oil pressure,boost) but never went near the ignition system and Clifford alarm is still flashing and arming/disarming.
But now the car wont start on its own. But it will if I run some jump leads from another car.
Before doing this I could remotely unlock and disarm the battery and start it.
Or if I left it too long i'd turn the key and then have to press the top button on the alarm to release the immobiliser. It used to make a click noise.
It does all this except the click noise now.
Car also now runs lumpy and wants to stall.
Any ideas please?
Thanks.
Last edited by ratboy; 04 May 2015 at 09:08 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 10:11 AM