First time using one of these and I've fitted a Fuelab. Haven't gone parallel at this time so it's just stock rails for now.

Am I right that the idle pressure should be set to 43.5psi? The mapper can then adjust it further if needed. I'm running standard pinks and a VF35 still as it stands.

Also, I've attached the rail adapter and ran a hose from here to the side of the FPR. The hose from the bottom of the FPR is going into the pipe that stock FPR went into originally. Any problems with that method?

 

in general terms it sounds correct

at idle with the vac line blanked off it will show approx 3BAR and when plumbed as normal approx 2.6BAR

 

Cheers Alyn