Location to put additional Knock Sensor????????
#1
![Question](https://www.scoobynet.com/images/icons/icon5.gif)
OK,
Where has everyone fitted their Knock Sensor on a MY94 WRX?
I have looked at previous posts and people have put it 5cm behind original one but I have no hole there?
The only place I can see is nearer the front of the engine and use the same bolt that is holding the Aircon/Altenator bracket on.
Cheer
Scott
Where has everyone fitted their Knock Sensor on a MY94 WRX?
I have looked at previous posts and people have put it 5cm behind original one but I have no hole there?
The only place I can see is nearer the front of the engine and use the same bolt that is holding the Aircon/Altenator bracket on.
Cheer
Scott
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
#2
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
![Post](https://www.scoobynet.com/images/icons/icon1.gif)
If you dont have any luck mate, i'll meet you over in harlow and show you where to mount it, you can buy the bolt needed from halfords..
Rob
p.s. wont be able to get over for a couple of days though..
Rob
p.s. wont be able to get over for a couple of days though..
#4
![Post](https://www.scoobynet.com/images/icons/icon1.gif)
Just behind the factory knck sensor but up on the machined area by the gearbox bell is a M8 tapped hole, it may be full of muck, bolt to that. Its just below the idle control valve
Bob
[Edited by Bob Rawle - 3/4/2003 10:50:00 PM]
Bob
[Edited by Bob Rawle - 3/4/2003 10:50:00 PM]
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
charlesr
General Technical
9
28 September 2015 09:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM