how do i get the airvents out from the middle of the dash board, the little vains have pushed out and i need to get the actual vent out to put them back in??

 

does no one know how to get the air vent out???

 

one for Dyney I think !

from what I remember, you have to pull them out as far as they come (only about an Inch) then there are 2 screws that are really fiddly to get at (need a really small / right angeled screwdriver) & then they come out.
dont pull too hard, or you will snap the lugs off.

Steve

 

Correct m8.
Just pull the entire vent section out, you can pull it to about 1 and half inch but thats it.
Then you need to undo the two screws behind, you will need a very small ratchet/socket type thing because its a beatch to do.

 

once i've got the main bit out then i will be able to remove the vent guide to put the vains back in? And to check, i just puu the whole thing and out it pops???