How to Spot an STi Engine???
22 October 2003, 01:04 PM
#1
Scooby Regular
Thread Starter
Join Date: Oct 2003
Location: The infamous 'Subaru Impreza Story' DVD Motor!
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
Folks,
Some technical help required here? I have had a STi version III engine fitted to my car (or so I am told). I should be picking it up this later this avo. The orginal WRX inlet manifold has been retained so there isn't the tell tale red manifold for confirmation.
Is there any way I can tell without stripping the engine that the bottom end is indeed from a STi version III car??? Thanks in advance for any/all advice given.
Cheers,
Kev
Some technical help required here? I have had a STi version III engine fitted to my car (or so I am told). I should be picking it up this later this avo. The orginal WRX inlet manifold has been retained so there isn't the tell tale red manifold for confirmation.
Is there any way I can tell without stripping the engine that the bottom end is indeed from a STi version III car??? Thanks in advance for any/all advice given.
Cheers,
Kev
22 October 2003, 02:12 PM
#2
Scooby Regular
Thread Starter
Join Date: Oct 2003
Location: The infamous 'Subaru Impreza Story' DVD Motor!
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
Question answered - spoken to TSL, and there apparently is no way to tell. I guess I'm just gonna have to trust the garage.. only.. I already don't trust them after 4 months and 3 attempts at a rebuild!
Thanks any way!
Thanks any way!
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM