Help / Advice needed....
#1
![Lightbulb](https://www.scoobynet.com/images/icons/icon3.gif)
I have aquired the prodrive ecu upgrade (part from a PPP). My mate had it fitted to his car, but then had a ecutek upgrade carried out. In doing this they (Power Engineering) removed the extra module (daughter board) from the ecu that prodrive put in. I am trying to get this fitted to my car but my local subaru dealer say they cannot fit it as they only normally get a complete ecu from prodrive as part of the PPP package that they just swap out. Apparently they do not have the technical ability / knowledge to carry this out! It has 5 wires that need soldering onto the ecu and 1 socket for a plug to be inserted (I can post a picture of the module if it is needed). Can anyone help advise me where I can get this fitted in the west london area? I have spoken to PE but they say they would not have made a note of where the wires came from in the ECU, so would not be able to refit it to another ECU. If I could supply a wiring diagram they would be able to do this.
Oh yeah, all this is for a 2002 wrx (bugeye)
Thanks in advance all
Rich
Oh yeah, all this is for a 2002 wrx (bugeye)
Thanks in advance all
Rich
Last edited by RoosterRoo; 01 July 2004 at 03:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM