nice easy one. how is the pipework situated for 2 port??
11 July 2004 | 03:33 PM
#1
nice easy one. how is the pipework situated for 2 port??
nice and easy, although i've totally forgotten
just replaced the 2 port boost solenoid there, but i'm getting overboost and fuel cut, so it obviously ain't right(wasn't 100%m sure about how the pipes were fitted). thought i'd give it a bash, but i now need someone to let me know where there go to from the 2 port to actuator and i/c inlet nipple and also where the breather pipe is t'd into the pipe?
thanks
just replaced the 2 port boost solenoid there, but i'm getting overboost and fuel cut, so it obviously ain't right(wasn't 100%m sure about how the pipes were fitted). thought i'd give it a bash, but i now need someone to let me know where there go to from the 2 port to actuator and i/c inlet nipple and also where the breather pipe is t'd into the pipe?
thanks
11 July 2004 | 10:14 PM
#3
Scooby Regular
Joined: Sep 2003
Posts: 2,720
Likes: 0
From: Isle of Wight
You should have a short piece of pipe coming from the compressor outlet with the restrictor in it, this then attaches to the T, the other end of which continues on to the wastegate actuator.
The bottom of the T goes off to the bottom connection of the solenoid. The top connection of the solenoid then connects to the air intake just after the MAF.
The bottom of the T goes off to the bottom connection of the solenoid. The top connection of the solenoid then connects to the air intake just after the MAF.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
29 December 2015 12:07 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 08:03 AM