hello all.. i installed the evc v 3 weeks ago worked great. settings as low 1.1 bar , high 1.3 bar and warning level at 1.4 bar. last night the B **** started to blink.!!! i switched the car off and on same to the unit by it self but it didnt change any thing. any information is much appreciated. thank you all in advance.

 

The EVC will lock the values when in monitor mode. So if you turn the **** in monitor mode, the **** will blink.

Press set check the value, turn the **** all the way to the left and all the way to the right, and then set the same value again.

It's just an indicator that the **** has been turned and is not "calibrated" anymore.

No harm done

 

thank you for your reply.. i readjusted again and its working fine now. can you please tell me what would the SET value do? when the workshop installed the device and adjusted it it was left to zero.