I have a 1995 WRX and am putting in a FETD05 with STI 4 manifold, uprated fuel rail with -6 ends and FSE FPR, hopefully at the weekend.

I am wanting to do away with the OE fuel pipes and put stainless steel Aeroquip hoses on and screw on connectors to connect the fuel rail and FPR, but dont know what size to order or where to get at a good price?

Has anyone ever fitted this stuff before to their car and have any pics or suggestions on what i need to do?

Also need to know how to adjust the FSE to run 3 bar with the vacuum pipe off?

 

Has noone fitted a modified fuel rail and FPR then?

 

Try the BBs on www.22b.com - there was a long thread on fuel rail modification.

 

Try www.oakbray.co.uk for fittings.
You will need -6 fittings.

Fuel pressure needs setting with a gauge on the fuel line, i have one permanently fitted to my FSE.

 

I know a gauge is needed i have one, but need to know how to adjust the regulator itself.

Do you have any pics of your installation?

 

No pics to hand.

Basically there is a locking nut on top of the reg which you remove which gives you access to the adjusting bolt. Whilst car is running, with vacuum line disconnected and blocked, turn the adjuster until desired fuel pressure achieved (3 bar standard) and then turn off, refit locking nut, check pressure again and finally reconnect vac hose.

 

Cheers mate