engine stalls
#1
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: stonehaven aberdeenshire
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
engine stalls
somtimes when on a run to work etc when i take the car out of gear the engine stalls doesn,y happen all the time but gettin anoying
my95wrx full decat,induction kit apexi ecu remapped
also what tmic upgrade would be recommended see a few on ebay
thanks for any help
my95wrx full decat,induction kit apexi ecu remapped
also what tmic upgrade would be recommended see a few on ebay
thanks for any help
#2
does it cut out or stall when slowing down? Could be "maf" sensor by the sound of it. Quite a common problem. what air filter do you run, is the element oil coated, if so, could be the reason for the failure, as the oil stickes to the sensor wire and alters the electrical values.
change sensor and refit proper paper element.
change sensor and refit proper paper element.
#3
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: stonehaven aberdeenshire
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by scoobyslut
does it cut out or stall when slowing down? Could be "maf" sensor by the sound of it. Quite a common problem. what air filter do you run, is the element oil coated, if so, could be the reason for the failure, as the oil stickes to the sensor wire and alters the electrical values.
change sensor and refit proper paper element.
change sensor and refit proper paper element.
unfortunatlly i fitted a pipercross viper kit coudnae resist the cost(i,ll pay for that in the long run methinks)so back to org air box an itg filter by the sounds of it so do i need a nother remap as it was remapped with induction kit on ?
thanks
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM