Help, Engine bung thread size/type?
15 February 2006, 03:19 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2003
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Help, Engine bung thread size/type?
Does anyone know what the thread size and type is in the engine block where the oil sensor is ( under the alternator )?
I am due to put in some guages that I bought recently and the new sensor is too big to go where the origional one is, so I need to put a 'T' piece in.
can anyone help me please as this would save a lot of time,
I have a 2001 WRX,
Many thanks, Hans.
I am due to put in some guages that I bought recently and the new sensor is too big to go where the origional one is, so I need to put a 'T' piece in.
can anyone help me please as this would save a lot of time,
I have a 2001 WRX,
Many thanks, Hans.
15 February 2006, 03:59 PM
#2
Scooby Regular
iTrader: (4)
Join Date: Sep 2005
Location: Worcestershire
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
The thread size in the bung is 1/8npt, but you will need to fit a remote t-piece if you are going to retain the original oil pressure switch for the dash light as there is not enough room under the alternator for a fixed tee. Demon Tweeks sell them for about £14 i think. Hope this helps.
Super time saver!
Thread
Thread Starter
Forum
Replies
Last Post