New Back box
05 March 2006 | 01:16 PM
#1
Thread Starter
Scooby Regular
Joined: Mar 2005
Posts: 3,272
Likes: 0
New Back box
Just picked up a new back box and would like advise on fitting.
Two bolt connection to centre section not a problem and neither are the rubber bung hangers.
It looks like the metal hook shaped hanger is tack welded to the exhaust, is this right.
If this is the case is it an angle grinder job ?
Anybody done this job ?
Cheers
Nik.
Two bolt connection to centre section not a problem and neither are the rubber bung hangers.
It looks like the metal hook shaped hanger is tack welded to the exhaust, is this right.
If this is the case is it an angle grinder job ?
Anybody done this job ?
Cheers
Nik.
05 March 2006 | 01:23 PM
#2
Angle grinder for what? I'd guess the hangers welded to the exhaust are to hang the exhaust with from the rubber hangers?
The rubbers just slide over the hangers a bit of wd40 will help
The rubbers just slide over the hangers a bit of wd40 will help
Last edited by Turbotits; 05 March 2006 at 01:28 PM.
05 March 2006 | 02:04 PM
#3
Thread Starter
Scooby Regular
Joined: Mar 2005
Posts: 3,272
Likes: 0
The rubber hangers are not a problem. A section of the exhaust is sat on a hook shaped metal hanger, its this that appears to be tack welded to the exhaust. Car is a MY03 STI by the way.
Originally Posted by Turbotits
Angle grinder for what? I'd guess the hangers welded to the exhaust are to hang the exhaust with from the rubber hangers?
The rubbers just slide over the hangers a bit of wd40 will help
The rubbers just slide over the hangers a bit of wd40 will help
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM