will the whole unit off a facelift model, the one with the cup holder behind the handbrake,fit onto the earlier model with no cup holder, the units look the same, just wondering if the holes etc are in different places ?

will it or wont it ?

cheers......

 

no one done this then?

 

No idea. But I can tell you where mine fixes (MY98 WRX) - when you flip the cupholder box's lid up, there are two screws down the bottom at the rear which go down into the floor, then there are also two concealed screws which allow you to remove the handbrake surround. With this off, you can see a single central screw that is under the handbrake lever holding thing down. Pull up the gearlever surround (which is only clipped in) and you can see two screws holding it to the bottom of the facia panel.

 

cheers,but i too own a later model, my00 and will be getting an my95 so need to know of the earlier fittings.

cheers again though........