ScoobyNet.com - Subaru Enthusiast Forum

Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Hub nut Torque settings.

Thread Tools
 
Search this Thread
 
Old 18 April 2006 | 10:54 AM
  #1  
[Davey]'s Avatar
[Davey]
Thread Starter
Scooby Regular
 
Joined: Feb 2006
Posts: 3,327
Likes: 1
From: Berkshire
Default Hub nut Torque settings.
Does anyone have these values to hand? Just about to refit a replacement hub and dont want to over tighten this one and be in the same boat as before
Reply Like
Old 18 April 2006 | 12:39 PM
  #2  
D1CCY's Avatar
D1CCY
Scooby Regular
 
Joined: Oct 2003
Posts: 1,966
Likes: 0
From: East Yorkshire
Default
2002 American WRX manual says 137 ft-lb front and rear. Can't imagine a UK car would be anyway different. Presume you mean the single big nut on the shaft.
Reply Like
Old 18 April 2006 | 01:19 PM
  #3  
[Davey]'s Avatar
[Davey]
Thread Starter
Scooby Regular
 
Joined: Feb 2006
Posts: 3,327
Likes: 1
From: Berkshire
Default
Yep the single nut.. Want to get it right because tappered bearings dont like being too tight.
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
How to: Android Nexus 7 HU install
JimBowen
ICE
5
02 July 2023 01:54 PM
Are newage STi & WRX Handbrake Shoes all the same?
KK3960
General Technical
3
07 October 2015 12:33 PM
Subaru full forged 2.1 blobeye 468 bhp
Ganz1983
Subaru
5
02 October 2015 09:22 AM
Clutch suggestions please
Scooby_Lee101
General Technical
3
26 September 2015 12:04 AM
Back to Subforum
General Technical
View Next Unread
Engine management light on at 7k rpm




Advanced Search
Quick Reply: Hub nut Torque settings.


Reply Closed Thread Share
Forum Jump

All times are GMT +1. The time now is 10:21 PM.