Ive fitted an apexi avcr today to my 99 uk wagon. The wiring up wasnt a problem but being new to subarus I got a bit stuck when it came to plumbing the soleniod in.

At the moment ive disconnected the original soleniod and connected the com from the apexi to the actuator. Then the no to the turbo outlet removing the T between them. I cant find the restrictor in the pipe though?

I take it ive got the correct solenoid the blue denso one?

Is this correct because it doesnt seem to be controling the boost. Boost goes up to 0.9 on apexi but even if I lower the boost setting it stays at 0.9

Any advise on how to plumb in or where the restrictor is would be appriciated

Cheers

 

As long as the sealed the pipe to the air intake then sounds correct.

lower the duty and check it makes less boost.

Simon