Advise
#1
Advise
Looking to get my STi V5 mapped at the powerstaion within the next few weeks so just have a few thoughts...
Im looking to get this mapped more so for "knowing" its running right, i.e. setup for UK fuel. The car had a full engine replacement when imported from the reciepts i have which was about 25k ago and it appears to be running sweet with no problems.
I assume that its about 280bhp running at 1.0bar? So was hoping for 300+ after the remap, what can i expect?
Only mods are full decat & K&N panel, the car is going in for cam belt next week and is fully serviced.
I'm assuming the STi fuel pump is up to the job?
Thoughts and comments please
Thanks
Im looking to get this mapped more so for "knowing" its running right, i.e. setup for UK fuel. The car had a full engine replacement when imported from the reciepts i have which was about 25k ago and it appears to be running sweet with no problems.
I assume that its about 280bhp running at 1.0bar? So was hoping for 300+ after the remap, what can i expect?
Only mods are full decat & K&N panel, the car is going in for cam belt next week and is fully serviced.
I'm assuming the STi fuel pump is up to the job?
Thoughts and comments please
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
22 September 2015 12:55 AM