upgrade to a 3 port boost solenoid for a MY99
23 June 2006, 01:34 PM
#1
Moderator
Thread Starter
iTrader: (4)
Join Date: Jul 2004
Location: The Terry Crews of moderation. P P P P P P POWER!!
Posts: 18,687
Likes: 0
Received 0 Likes
on
0 Posts
upgrade to a 3 port boost solenoid for a MY99
Hi all,
Am having an Ecutek remap at the end of next week and am just shopping for my pre-map mods!
Since I'm upgrading the turbo, a 3 port boost solenoid is on the list, and there seem to be some good deals to be had getting these from a breaker (Grade A).
I'm just a little concerned about compatability as presumably these will be from earlier turbos. Will these be ok? Is there a particular variety I need to look out for or are they all the same?
Best wishes,
Paul
Am having an Ecutek remap at the end of next week and am just shopping for my pre-map mods!
Since I'm upgrading the turbo, a 3 port boost solenoid is on the list, and there seem to be some good deals to be had getting these from a breaker (Grade A). I'm just a little concerned about compatability as presumably these will be from earlier turbos. Will these be ok? Is there a particular variety I need to look out for or are they all the same?
Best wishes,
Paul
23 June 2006, 02:08 PM
#3
Moderator
Thread Starter
iTrader: (4)
Join Date: Jul 2004
Location: The Terry Crews of moderation. P P P P P P POWER!!
Posts: 18,687
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BOB'5
3 ports are 3 ports. Going rate seems to be about £50 used.
Paul
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM
