Bought one of these today, installed as per manual and all that happend was that the function buttons glowed orange? without meaning to sound stupid is this supposed to happen? If its a problem does anyone know what it is and how to recitfy said issue?

Tom

 

have you used both ground wires? black and green from memory.. ensure they have a good ground.. to negative battery if necessary..

Simon

 

yes i did actually connect them to battery in the end, again all that happend was the buttons lit up...

 

anyone any suggestions?

 

Its either faulty or you have wired it incorrectly and fried something.

When functioning properly apexi avcr logo should light up on the screen and then turn to your settings.

 

what scoobboy said..

try just the power and grounds connected and see if it works..

Simon

 

yes have done still only buttons light up must be faulty, dissappointing (its not difficult enough to wire in and fry it!)