i bought a classic decat downpipe but will it fit td04+td05 uk and jap ?????
05 March 2007, 10:55 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2006
Location: sunshine coast, queensland ! hot hot hot !
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
i bought a classic decat downpipe but will it fit td04+td05 uk and jap ?????
i am unsure if it was from a uk or jap car and if it was fitted to a td05 or td04 . does it matter (it was second hand but not old) ?? are they the same flange shape and stud patern ?? the local garage just put some doubt in my mind... can anyone confirm ?? mines a 555 sti ..its going onto a apexi rear+middle section too......
05 March 2007, 11:04 PM
#2
Scooby Senior
Join Date: Feb 2003
Location: West Midlands
Posts: 1,903
Likes: 0
Received 0 Likes
on
0 Posts
It should fit ok on the turbo side.
You just need to make sure if its tapers down from 3" to the standard fit ment of the centre section pipe. I thinks that bit is 2.5"
You just need to make sure if its tapers down from 3" to the standard fit ment of the centre section pipe. I thinks that bit is 2.5"
Thread
Thread Starter
Forum
Replies
Last Post
BHPvstorque
Subaru Parts
1
14 September 2015 08:31 PM