33 Vehicle Speed Sensor
30 March 2007, 09:26 PM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2006
Posts: 3,214
Likes: 0
Received 0 Likes
on
0 Posts
33 Vehicle Speed Sensor
33 Vehicle Speed Sensor
Can someone comfirm that fault code 33 is as above. Also:
Where is the speed sensor?
How do I change it?
Does anyone have one lying around?
Cheers guys and dolls..
30 March 2007, 09:30 PM
#2
Scooby Regular
Thread Starter
Join Date: Aug 2006
Posts: 3,214
Likes: 0
Received 0 Likes
on
0 Posts
The speedo stopped working today, not long after I refitted the clocks. If I have pull the cable out at the gearbox end would that cause fault 33?
Last edited by dan83590; 30 March 2007 at 09:35 PM.
30 March 2007, 09:37 PM
#3
Scooby Regular
Join Date: Jan 2006
Location: North Wales
Posts: 931
Likes: 0
Received 0 Likes
on
0 Posts
if you havent connected the speedo cable into the back of the speedo dial it throws up that fault code so the sensor may be in the speedo cluster
The cable is quite short so difficult to put back in when refitting the speedo cluster... easiest way I found it fit the cluster then lie on your back in the footwell and use a torch to find the cable and where it fits and fit it from under there.
Gaz
The cable is quite short so difficult to put back in when refitting the speedo cluster... easiest way I found it fit the cluster then lie on your back in the footwell and use a torch to find the cable and where it fits and fit it from under there.
Gaz
31 March 2007, 06:27 PM
#7
Scooby Regular
Thread Starter
Join Date: Aug 2006
Posts: 3,214
Likes: 0
Received 0 Likes
on
0 Posts
Future searches.
Problem sorted.
Speedo cable was indeed disconnected at both ends. To re-connect it at the gearbox side you need to look down between the downpipe and the intercooler, there you will see the speedo cable pointing vertically upward from the gearbox. You can reach it (just) with the exhaust cold. From the speedo end it can be reached if you lay on your back and feel your way around toward the back of the speedo cluster.
Speedo cable was indeed disconnected at both ends. To re-connect it at the gearbox side you need to look down between the downpipe and the intercooler, there you will see the speedo cable pointing vertically upward from the gearbox. You can reach it (just) with the exhaust cold. From the speedo end it can be reached if you lay on your back and feel your way around toward the back of the speedo cluster.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM