Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Lift off det

Thread Tools
 
Search this Thread
 
Old 16 August 2007 | 10:28 AM
  #1  
RAPID RABBIT's Avatar
RAPID RABBIT
Thread Starter
Scooby Regular
iTrader: (10)
 
Joined: Jul 2006
Posts: 592
Likes: 0
From: ?
Default Lift off det

Morning all.
I've been logging a few runs on datalogit and have noticed i'm getting det 40/50 on lift off?
the injectors are at 0% at this stage and timing is at about 35 so i should not get det right?
anyhelp appreciated.
Old 16 August 2007 | 11:15 AM
  #2  
Mocom Racing's Avatar
Mocom Racing
Former Sponsor
iTrader: (2)
 
Joined: Feb 2005
Posts: 837
Likes: 0
From: workshop tel: 01787 275074
Default

Exactly why you are getting det.
Look at your logs and you'll see the ignition timing increase when you lift off.
Old 16 August 2007 | 11:21 AM
  #3  
RAPID RABBIT's Avatar
RAPID RABBIT
Thread Starter
Scooby Regular
iTrader: (10)
 
Joined: Jul 2006
Posts: 592
Likes: 0
From: ?
Default

Its happenning at high rpm and load as i let off but stay in gear and trails down the scale a bit.
Ignition timing there was 45 which i then lowered to 35 but still get the knock .
as soon as it lowers below 5k rpm it goes.
i'll give it another run at 25 ignition
i did'nt think knock was possible on over run when no fuel is going in?
Old 16 August 2007 | 01:28 PM
  #4  
jaytc2003's Avatar
jaytc2003
Scooby Regular
iTrader: (1)
 
Joined: Aug 2005
Posts: 18,547
Likes: 0
From: Manchester ish
Default

Not exactly subarus I know but the following link has some lift off det experienced by John Banks so there may be some answers in there.

Mitsubishi Lancer Register Forum - Lift off detonation
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Krissyb-P1
Subaru Parts
3
11 February 2016 09:17 PM
spider
Car Care
6
05 October 2015 10:50 AM
legb4rsk
Non Scooby Related
14
01 October 2015 06:18 AM
P1-Murph
Subaru Parts
3
28 September 2015 12:29 PM
karloskarlotti81
ScoobyNet General
19
21 September 2015 04:10 PM




All times are GMT +1. The time now is 01:23 AM.