Apexi power fc and boost controller
26 August 2007, 06:19 PM
#1
Scooby Regular
Thread Starter
iTrader: (10)
Join Date: Jul 2006
Location: ?
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Apexi boost controller fitting
I need a bit of advice on fitting the boost controller to my 95 sti.
I have an apeci ecu and relavent software for tuning.
I allready have a 3 port solenoid on the car, will this be good enough.
At the moment the map sensor is plumbed inline with the presure sauce switching solenoid. Should i remove the old map sensor and replace with the new one provided in original place.
Should i completly remove the old map sensor and solenoid and replace with the new kit?
What bits stay and which can be bined?????
Has anyone got any diagrames or pictures of how you have installed it.
I cant read jap lol
Anyhelp greatful
cheers
I have an apeci ecu and relavent software for tuning.
I allready have a 3 port solenoid on the car, will this be good enough.
At the moment the map sensor is plumbed inline with the presure sauce switching solenoid. Should i remove the old map sensor and replace with the new one provided in original place.
Should i completly remove the old map sensor and solenoid and replace with the new kit?
What bits stay and which can be bined?????
Has anyone got any diagrames or pictures of how you have installed it.
I cant read jap lol
Anyhelp greatful
cheers
Last edited by RAPID RABBIT; 27 August 2007 at 10:39 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM