I have a 94 wrx with:-


2.5 sti bottom end
Eagle forged rods
Wiseco forged pistons
sti4 ported heads
Owen's 475+ bhp Garrett turbo
Hydra ECU
740 injectors
Fuel Lab pressure reg
Walbro 255
Gt spec manifold + upipe
H+S downpipe
Buddy Club prospec4 exhaust
Front Mount Intercooler
Custom Induction Kit Built into inner wing.


Its being mapped on Friday By Richard Bulmer from Tracktive, so let me see your predictions and see who gets closest.



Cheers Dougie

 

i would say as a guess 485 bhp

 

That sounds good to me, Keep em coming

Cheers Dougie

 

Come on guys give us your opinions

 

what rolling road?

 

Hi Paul

Richard Is mapping it on the road, but I have got it booked in on a Dyno Dynamics on saturday as a friend going to map his skyline, so I thought I would give it a run.



Cheers Dougie

 

with all that i would say a good 450ponys

 

Thats what im hoping for , Anything more will be a bonus. I will keep you posted.

Keep em coming

 

Back up for Paul from ZEN, interested in your opinion.


Cheers Dougie

 

453/450

 

I will give you a ring Friday, to let you know how it is.

Dougie

 

I think you'll be dissapointed with the numbers, but amazed with how it drives. 435hp, 440ft-lb but it depends on the boost. It will be making more on the road.

 

Will be interested to see what you get mate as i have gone for the same turbo but still on a 2.0 so ill have a lot less torque than you.

 

Cheers for the replys, I will let you know on saturday what figures it gets. Good one's I hope, its cost me enough .


thanks dougie

 

I think it will be around 465bhp, and 460lbs of torque,,

 

whats it pushin then mate

 

Hi fella's , sorry about the delay. Had it mapped on friday but not to full potential as Richard was getting worried about my standard uk spec gearbox as it was starting to feel a bit tight and didnt want to say its mapped but your gearbox is in bits. Anyway I had it rolled on a dyno dynamics on saturday with an open mind and I think it did well. I had two maps done one at 0.9 and it got 315bhp and at 1.2 it got 380bhp with 400lbft, and it goes like ****, so my next plan is to get a ppg helical cut 1/4 gear kit and get it tweaked by Richard again and then we should be really cookin.

cheers for your interest I should have the gearbox and map done in about a month, so we will see what she does then

Cheers Dougie

 

What is the max that richard would take it to, over 1.6 bar i presume on your spec engine, does he say it could do around the 470bhp mark,,,
It must be abit laggy mate at only 1.2 bar

 

It doesn't feel laggy, I looked at my boost gauge and its pulling about 1bar by 3000revs. We havn't really spoke about figures, he said after he mapped it that there is plenty left in it,and I asked "do you think it could get 450/450" and his reply was "easy", so we will just have to see what happens when I get the new gearbox, which is probably gonna be sooner rather than later but don't tell the wife .


Dougie

 

Told you....get that gearbox sorted m8 and it will fly