Apexi fc question
02 September 2007, 10:32 AM
#1
Scooby Regular
Thread Starter
iTrader: (10)
Join Date: Jul 2006
Location: ?
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Apexi fc question
Hi,
I've just fitted the map sensor which plugs into the ecu.
Problem i have is the car splutters on boost?
I still have the orignal map sensor fitted not sure if it needs taking out.
The new one i have T'd off just after the presssure switching solenoid.
How have you done yours?
Any help welcome
I've just fitted the map sensor which plugs into the ecu.
Problem i have is the car splutters on boost?
I still have the orignal map sensor fitted not sure if it needs taking out.
The new one i have T'd off just after the presssure switching solenoid.
How have you done yours?
Any help welcome
03 September 2007, 11:46 PM
#2
Now then!
I have my OE sensor in place, although I use the AVCR and its own sensor.
You should have this t'd into the feed to the original map sensor and possibly as close to the manifold as you can get it. I'm not sure where you have t'd yours to be honest.
How do you mean "just after the pressure switching solenoid"?
Is this the boost soleniod?
I have my OE sensor in place, although I use the AVCR and its own sensor.
You should have this t'd into the feed to the original map sensor and possibly as close to the manifold as you can get it. I'm not sure where you have t'd yours to be honest.
How do you mean "just after the pressure switching solenoid"?
Is this the boost soleniod?
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM