440 injector fuel pressure
#1
Scooby Regular
Thread Starter
Join Date: Oct 2006
Location: nr,chesterfield
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
just fitted some 440s recently and wondered what the fuel pressure should be
its currently set at just over 3bar with vac off would this be ok or will it need increasing?
car is going for remap on thursday wanted to make sure it was somewhere near before
any help or advice plz
its currently set at just over 3bar with vac off would this be ok or will it need increasing?
car is going for remap on thursday wanted to make sure it was somewhere near before
any help or advice plz
#3
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
discuss it with mapper on the day.. as it is only a 2minute job to alter it..
depending on their experiances and preferences with different pressures and set ups you should be able to get the best out of your set up, to comment without the full picture when your are visiting someone that will have it in front of them will hinder..
ie. what fuel pressure reg, are fuel lines braided, what turbo, what are you aiming for.. etc. for reference standard pressure is around 3bar and you should be okay driving off boost to meet mapper.
Simon
depending on their experiances and preferences with different pressures and set ups you should be able to get the best out of your set up, to comment without the full picture when your are visiting someone that will have it in front of them will hinder..
ie. what fuel pressure reg, are fuel lines braided, what turbo, what are you aiming for.. etc. for reference standard pressure is around 3bar and you should be okay driving off boost to meet mapper.
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
hedgecutter
General Technical
3
25 September 2015 02:35 PM