3-Port Boost Solenoid+ info (with pic)
22 February 2008, 11:07 PM
#1
Scooby Newbie
Thread Starter
Join Date: Apr 2004
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
3-Port Boost Solenoid+ info (with pic)
Greetings,
Short of rippng out the intake tract and tracking each hose from end-to-end I cannot see where each of the lines is specifically coming from/to. Please could someone confirm the to/from status of each of these lines? Greatly appreciated
Note: Early Classic WRX
Short of rippng out the intake tract and tracking each hose from end-to-end I cannot see where each of the lines is specifically coming from/to. Please could someone confirm the to/from status of each of these lines? Greatly appreciated
Note: Early Classic WRX
22 February 2008, 11:49 PM
#2
1. goes to map sensor
2. goes to compressor bypass signal line
3. goes to compressor/turbo outlet
4. goes to actuator
5. goes to air inlet/air intake resonator box or just leave it hanging loose
Last edited by slipstream_uk; 23 February 2008 at 02:10 AM.
23 February 2008, 01:40 AM
#3
Scooby Newbie
Thread Starter
Join Date: Apr 2004
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Hi Slipstream, cheers for the input 
Your diagram shows #3 labelled as 'Turbo Outlet Nipple' however you've identified it as '3. goes to wastegate'. Your digram has #4 listed as 'Actuator Connection' which would be 'going to wastegate'?
Any clarification? Note: If I've mixed up my terms please correct!
Your diagram shows #3 labelled as 'Turbo Outlet Nipple' however you've identified it as '3. goes to wastegate'. Your digram has #4 listed as 'Actuator Connection' which would be 'going to wastegate'?
Any clarification? Note: If I've mixed up my terms please correct!
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM