My RB5 has the following mods:

Ninja Downpipe with Fast flow Cat
Ninja de-cat centre section
Ninja back box
NGK pfr7b plugs
K and n panel filter
Graham Goode Racing Tek 3 remap

What power do you think my car is running with the above mods^^^^^


If i was to put on either the roger clark or graham goode induction kit would i need to get the car re-mapped again??
Also what kit is the best?

 

you would prob need a map tweek i should think, im sure the rcm is a k&n filter and alot of people use the k&n one on here

 

RCMS kit is very good, i doubt you would need it though tbh with what you have as i would have thought that you are looking at about 280/290ish on your current set up, If you do fit one, i'd get the mapped checked/tweeked.
You will be safe for about 350bhp on the Std airbox iirc, although i stand to be corrected by an expert?
Bear in mind though that the MY99/00 cars are well known for having fragile MAF's and many on here have had issues when fitting induction kits.
The problem however, does not lie with the filtration or the extra air the MAF encounters, it's excessive vibration caused by rubbish kits that don't fit very well and harm the MAF, the RCMS kit is not a rubbish kit.

 

Thanks for the help chaps

 

I have the GGR Kit on my RB5, Jay!

The Cone is K&N but much bigger than the K&N 57i Kit and I think the same size as the RCMS one.

So far had no problems with it and like the RCMS its supposed to be MAF friendly for our MY99 cars.