Stalling after 5 secs EVERYTIME!!!!
#1
Stalling after 5 secs EVERYTIME!!!!
My WRX95:
Starts and then it dies after 5 seconds everytime!!!!
Have tried:
Flushing all fuel
New ECU
Tried sensors, no codes on reader.
Timing is OK
It starts idles aroudn 2k, then just dies out. Doesnt like gas pedal to keep revs up either, just dies!!!
Any idea's please.
Starts and then it dies after 5 seconds everytime!!!!
Have tried:
Flushing all fuel
New ECU
Tried sensors, no codes on reader.
Timing is OK
It starts idles aroudn 2k, then just dies out. Doesnt like gas pedal to keep revs up either, just dies!!!
Any idea's please.
Trending Topics
#10
I didnt do the test that way, my mechanic tested on a subaru test device
(he works at a main dealers)
First time round loads of codes came up, then tested removed, refitted sensors and nothing comes up now.
The car just dies with revs at aroudn 5 secs, it trys to settle, then as calms down, it goes all the way down and stalls
(he works at a main dealers)
First time round loads of codes came up, then tested removed, refitted sensors and nothing comes up now.
The car just dies with revs at aroudn 5 secs, it trys to settle, then as calms down, it goes all the way down and stalls
#11
this may be way off but i remember the old vauxhall motronic set up and wen the car was cold the water temp senser would tell ecu it was hot and shut the idle fuel down or off totaly so its not enough to keep it running so stalls.. may be its this case the sensor is that bad its just shuting fuel right down????????
just a thought...
just a thought...
#12
im kinding of having the same problem,on warm start up it starts straight away,but revs die to around 200 revs before kicking back up again,hasnt stalled as of yet tho,just annoying...let me know how u get on mate
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 12:07 PM
aaron_ions
General Technical
1
17 September 2015 11:42 AM