hi im going to fit a vf34, ecutek 3 ecu,and milltek sports cat exhaust ive been told this will produce about 320bhp but not sure on what sort of torque figure

does 340Nm sound right

 

You should get about the same bhp/ftlb. I believe that the VF34, should give about 350*350 max on Vpower

 

I've had 360bhp (confirmed on dyno) out of my old vf34 , gr8 turbo for everyday use

 

what other mods did u have to get 360bhp?
what torque was that producing?
what dyno?

 

mods are aps fr mount intercooler , aps cold air kits , 550s injectors, walbro fuel pump, fxs fuel regulator, gruppe-S headers with decat downpipe and decat centre section , blitz nur-spec rear box,mrt turbo inlets pipe, and of cause a motec m800 ecu

had its around 380 bhp ....then turn its back down to save the gearbox
torque was same as bhp, to get thet kind of power the boost was running at 1.8 bar , but no problems when it was running that kind of boost with the car .
but i don't reccomend it though ...i would stay around 1.5-1.6 to be safe

Dyno was Dyno dynamics