I recently purchased the Apexi Power FC boost control kit and received instructions in Japanese. The install doesn't seem particularly complicated but I was wondering if anyone had the instructions in English. I have the commander and PFC instructions in english, so I would imagine they exist for this unit as well. Can anyone help me out?

I have a couple quick questions about the installation, since there are alot of extra bits and connectors in the kit:

There are 3 ports on the Apexi boost solenoid, does the third port vent to atmosphere or back to the pre-turbo intake like the factory boost solenoid?

Is it required to retain the stock restrictor pill between the compressor outlet and boost solenoid?

Lastly, the map sensor is placed on a post throttle body vacuum line to register proper manifold pressure at all times, correct?

Thanks for the help!

 

Pre turbo intake, but you can vent it to air.

No.

Yes.

 

Intsallation manual
http://www.apexi-usa.com/pdf/product...tation/200.pdf

Vehicle specific wiring diagrams
http://www.apexi-usa.com/pdf/technic...tation/200.pdf

 

A couple more questions.

1. When installing the boost control kit, do you leave the stock map sensor plugged in and reading?

2. Do you disconnect completely the stock boost solenoid (electrical connection and compressor/wastegate/bleed hoses)?

3. In the commander, what is the proper setting for use with the boost control kit? (In the 'etc' menu, you can enable or disable boost control).