took out my panel filter for a clean, now the car sounds like darth vader!
#1
Thread Starter
Scooby Regular
iTrader: (1)
Joined: Sep 2003
Posts: 4,721
Likes: 0
From: gravesend, kent
took out my panel filter for a clean, now the car sounds like darth vader!
i took my green cotton filter out of the airbox to give it a brush off and check it over as it's not been looked at for a while, but now there's a bit of induction noise going on
i asumed i hadn't put the box back together properly or the filter hadn't seated properly, but everything looks fine. even took the pipework off to make sure everything is where it should be.
sounds a bit like an atmospheric d/valve? only really make a whoosh backing off at 3-3.5k revs.
are there any pipes that i might have knocked off or anyone have any other ideas?
cheers,
Paul
i asumed i hadn't put the box back together properly or the filter hadn't seated properly, but everything looks fine. even took the pipework off to make sure everything is where it should be.
sounds a bit like an atmospheric d/valve? only really make a whoosh backing off at 3-3.5k revs.
are there any pipes that i might have knocked off or anyone have any other ideas?
cheers,
Paul
#4
Thread Starter
Scooby Regular
iTrader: (1)
Joined: Sep 2003
Posts: 4,721
Likes: 0
From: gravesend, kent
thanks guys, i think i'll pull everything out to properly check. the clips look ok butty, but again i'll double check.
i seem to remember a small pipe fitting into the bottom of the induction pipe on my old classic, is there anything like that on a newage?
i seem to remember a small pipe fitting into the bottom of the induction pipe on my old classic, is there anything like that on a newage?
#6
i ve got a green panel in my 05 wrx and it is a slight bit noisier than standard on the induction noise... maybe as the filter is cleaner now its also noisier and you have forgotten what it sounded like
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM