FMIC Intercooler hose sizes
08 December 2008, 06:39 PM
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Jan 2003
Location: South Wales - Stuck on this rollercoaster, get me off!!
Posts: 5,350
Likes: 0
Received 0 Likes
on
0 Posts
FMIC Intercooler hose sizes
I'm looking to replace the hose clamps on my Hybrid FMIC, I'm pretty sure the bulk of them are 68 - 73 mm?
Not aure what the inlet manifold size is, does anyone know?
simb
Not aure what the inlet manifold size is, does anyone know?
simb
08 December 2008, 07:37 PM
#2
I just happen to have an v.1/2 TMIC lying around and I've just measured the outer diameter of its throttle body outlet, and it was exactly 70mm. So with the thickness of the silicone hose's walls being about 4mm thick, that makes the overall diameter c.78mm.
So I reckon you should get 65-80mm clips or similar.
So I reckon you should get 65-80mm clips or similar.
Last edited by joz8968; 08 December 2008 at 07:43 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM