what injectors for 500+bhp
#1
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
what injectors for 500+bhp
hi, just need to know what size injectors ill need for around 500 bhp, and do the later v5-v6 sti injectors fit in the v1-v2 sti fuel rails, thanks phil.
Last edited by thewhitewarrior; 07 January 2009 at 06:11 PM.
#4
Scooby Regular
I run 800cc v-port injectors . . .
Bought them from
http://www.andyforrestperformance.co...7A93/oben4.gif
Also had my Turbo in inlet pipe from Andy... Ring him or email him... I'm sure he'll advise you after running through your spec
Bought them from
http://www.andyforrestperformance.co...7A93/oben4.gif
Also had my Turbo in inlet pipe from Andy... Ring him or email him... I'm sure he'll advise you after running through your spec
#6
Scooby Regular
800cc's at standard fuel pressure will be close if not on the limit. I had to change from 800's when going over 500bhp, but that was at standard fuel pressure and the standard Spec C pump. Had I even ran with my current Bosch pump on standard fuel pressure I may of been ok.
Trending Topics
#8
Scooby Regular
There was plenty left out of the 800cc V-ports... I was advised by Andy Forrest these would be fine for my spec
I run uprated fuel pump and Cossie FPR with parrallel fuel rail mod...
I run uprated fuel pump and Cossie FPR with parrallel fuel rail mod...
#12
#13
Scooby Regular
iTrader: (4)
Join Date: Nov 2007
Location: Devon
Posts: 445
Likes: 0
Received 0 Likes
on
0 Posts
I have 1000cc top feeds on my 97 type r but have a parallel rails that also converts to top feed injectors.
Running 530bhp with the injectors at about 75 - 80 % capacity. Had some 850cc Deatschwerks injectors on there before but maxed them out at 480 bhp.
Also using a bosch in-tank pump.
Running 530bhp with the injectors at about 75 - 80 % capacity. Had some 850cc Deatschwerks injectors on there before but maxed them out at 480 bhp.
Also using a bosch in-tank pump.
#18
Scooby Regular
Join Date: Nov 1999
Location: Nottingham with 620BHP & 530lb/ft @1.5bar boost on road fuel.
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
740's should be sufficient for 500, 850's will have room to spare (with the right fuel system). We flow test and match our injectors.
Jase.
Jase.
#19
I have 1000cc top feeds on my 97 type r but have a parallel rails that also converts to top feed injectors.
Running 530bhp with the injectors at about 75 - 80 % capacity. Had some 850cc Deatschwerks injectors on there before but maxed them out at 480 bhp.
Also using a bosch in-tank pump.
Running 530bhp with the injectors at about 75 - 80 % capacity. Had some 850cc Deatschwerks injectors on there before but maxed them out at 480 bhp.
Also using a bosch in-tank pump.
The following users liked this post:
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM