Advise what next
#1
Advise what next
what should i add next....
Ok so far on my 02 WRX ive got (engine wise):
Powertec Impreza Induction Kit.
Autobahn88 Front Mount Intercooler.
HKS Super Sequential Blow Off Valve.
Ninja Downpipe with Fast flow Cat.
Afterburner Cat Pipe.
Afterburner Centre Section.
Ninja II End Section.
no re-maps or out yet.
What should i do next? i was thinking
Agency Power Fuel Rails.
IHI VF34 Turbocharger.
650cc Sard fuel injectors.
Walbro Motorsport GSS342 255 litres per hour high pressure in tank uprated fuel pump with installation kit.
Aeromotive fuel pressure regulator with installation kit.
and a re-map
Is this a wise choice?
I'm looking in the end to be getting about 350 to 400 BHP out of her. obviously i'll need uprated clutch, gearbox and so on be4 that power but as a starting point
also i think i read sumwhere that you shouldnt put new injectors in untill the time of the re-map?
Thanks for the advise
Ok so far on my 02 WRX ive got (engine wise):
Powertec Impreza Induction Kit.
Autobahn88 Front Mount Intercooler.
HKS Super Sequential Blow Off Valve.
Ninja Downpipe with Fast flow Cat.
Afterburner Cat Pipe.
Afterburner Centre Section.
Ninja II End Section.
no re-maps or out yet.
What should i do next? i was thinking
Agency Power Fuel Rails.
IHI VF34 Turbocharger.
650cc Sard fuel injectors.
Walbro Motorsport GSS342 255 litres per hour high pressure in tank uprated fuel pump with installation kit.
Aeromotive fuel pressure regulator with installation kit.
and a re-map
Is this a wise choice?
I'm looking in the end to be getting about 350 to 400 BHP out of her. obviously i'll need uprated clutch, gearbox and so on be4 that power but as a starting point
also i think i read sumwhere that you shouldnt put new injectors in untill the time of the re-map?
Thanks for the advise
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
22 September 2015 12:55 AM