Knocklink LED adjustment
#1
Knocklink LED adjustment
i have a knocklink fitted,i opened it up and removed the led`s, extended them etc and put the LED`s between my speedo/rev counter,looks much better, cool.
but drillin the holes for them was hard to get them 100% in line so 1 or 2 go slightly sqewif doesnt look bad but bugs me
is there any other LED already made lights that are multi coloured i could mount there, or any type of like coloured line bit like the memory usage on ypur p.c in task manager out there i could use, starts off green and goes amber red in lines etc
but drillin the holes for them was hard to get them 100% in line so 1 or 2 go slightly sqewif doesnt look bad but bugs me
is there any other LED already made lights that are multi coloured i could mount there, or any type of like coloured line bit like the memory usage on ypur p.c in task manager out there i could use, starts off green and goes amber red in lines etc
#3
yeah,cheers, maybe i didnt quite type clearly.
i have already done that, my knocklink box is near my ashtray and used IDE Cable to entend the LED`s into my dash,but as i say the holes i drilled are not 100% in line so want a pre-made LED Graph block etc to make it look better,like this
20 SEGMENT BAR GRAPH ARRAY High Efficiency Red on eBay, also, Components, Accessories, Consumer Electronics (end time 24-Mar-09 15:45:04 GMT)
wondering if anyone has used or know of better
cheers
i have already done that, my knocklink box is near my ashtray and used IDE Cable to entend the LED`s into my dash,but as i say the holes i drilled are not 100% in line so want a pre-made LED Graph block etc to make it look better,like this
20 SEGMENT BAR GRAPH ARRAY High Efficiency Red on eBay, also, Components, Accessories, Consumer Electronics (end time 24-Mar-09 15:45:04 GMT)
wondering if anyone has used or know of better
cheers
Thread
Thread Starter
Forum
Replies
Last Post
jonnyboy82
Lighting and Other Electrical
0
29 September 2015 01:59 PM