engine build advice
30 March 2009, 11:16 PM
#1
Scooby Regular
Thread Starter
Join Date: Mar 2008
Location: south yorkshire,sheffield.
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
engine build advice
just wondering if anyone can shed a little light on one or 2 issues for me
ive built a couple of impreza engines before but only in standard form,now im wanting to build my own forged motor and not entirely sure what fits what and so on,so here goes
1.im goint to be using a 2.0 closed deck block,what heads will fit it and what wont?
2.can a centre thrust block be converted to rear thrust
3.would a standard crank with a minimal grind and acl race series bearings live up to 380-400 hp with supporting mods.
thanks in advance peeps!
ive built a couple of impreza engines before but only in standard form,now im wanting to build my own forged motor and not entirely sure what fits what and so on,so here goes
1.im goint to be using a 2.0 closed deck block,what heads will fit it and what wont?
2.can a centre thrust block be converted to rear thrust
3.would a standard crank with a minimal grind and acl race series bearings live up to 380-400 hp with supporting mods.
thanks in advance peeps!
31 March 2009, 11:21 AM
#3
as above, starting from the bottom up, forget number 3 unless you want tears before bed time! as for number 2 yes you can machine the block for rear thrust bearing, and number one i believe any heads will bolt on but you need to make sure the compression ratio right.
Thread
Thread Starter
Forum
Replies
Last Post
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM