Help, confusion - new maf engine choky
#1
Help, confusion - new maf engine choky
As some my know, my maf went, the car runs fine with out one but only limited to 20mph,it did come up with error 23.
Now I replaced it with new one, reset ECU and there is no errors.
But
The engine is really bad chokin, idles range from 1500 to 500 to stalling. I can put my foot on the gas and it ither chokes no power or revs.
Theres no error code, it flashes evenly.
HELP
PS it is the right Maf because I bought 2 so and it happens to both of them.
Havent a clue what it could be.
Now I replaced it with new one, reset ECU and there is no errors.
But
The engine is really bad chokin, idles range from 1500 to 500 to stalling. I can put my foot on the gas and it ither chokes no power or revs.
Theres no error code, it flashes evenly.
HELP
PS it is the right Maf because I bought 2 so and it happens to both of them.
Havent a clue what it could be.
Last edited by nigel101; 29 July 2009 at 07:30 PM.
#2
Plugged in, engine choking badly, idles between 500-2000 eratic, stalls, sometimes it responses to gas pedal.
Not Plugged in, engine choking (sounds like a chopper bike), smell of petrol, idles 1500, ok to drive but limited to 25mph, and is bit kangrooly, bouncy.
No error codes. Can do a video put it on later.
Not Plugged in, engine choking (sounds like a chopper bike), smell of petrol, idles 1500, ok to drive but limited to 25mph, and is bit kangrooly, bouncy.
No error codes. Can do a video put it on later.
#3
this is doin my **** in, no error code, still eratic idle and stalls.
Mate says it could be ecu or temp sensor on engine block.
Where can i get a detailed manual of a wrx 94 impreza? (free )
Mate says it could be ecu or temp sensor on engine block.
Where can i get a detailed manual of a wrx 94 impreza? (free )
#4
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 11:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 06:26 PM