header and uppipe blanking bolts
#1
Scooby Regular
Thread Starter
Join Date: May 2009
Location: yorkshire
Posts: 249
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Hi guys just got me new headers and uppipe from flat4 after a 4 week wait
and they come with screw holes for some temperature sensors my v5 duz not need theses so do u guys no were to some bolts to blank these off? my nut and bolt shop duz not have any he says it a 1.25mm thread, thk for any help guys
![Mad](https://www.scoobynet.com/images/smilies/mad.gif)
![Thumb](https://www.scoobynet.com/images/smilies/thumb.gif)
#2
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
this happened to me mate. i f***ked mine an knocked a nut into it an tightenin an smaler bolt into it only findin it leaks round the egdes. so have to weld the gaps now. i couldnt find any either an weldin is my best bet unless find the sensors to go in an thats all. but there pricey
#3
Scooby Regular
iTrader: (1)
Join Date: Oct 2004
Location: Half way up
Posts: 4,791
Likes: 0
Received 0 Likes
on
0 Posts
![Lightbulb](https://www.scoobynet.com/images/icons/icon3.gif)
You can easily get the correct bung from a main dealer for a few quid. Iirc it's the same size as main gallery bung/plug at M18x1.25..?
Maybe a generous SN member who's recently fitted an oil temp gauge into the gallery above cyl #3 still has the bung knocking around for the cost of a stamp and beer..?
Maybe a generous SN member who's recently fitted an oil temp gauge into the gallery above cyl #3 still has the bung knocking around for the cost of a stamp and beer..?
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM