they are froma late model sti, do i need a modified feul rail to fit these to my version 1 sti? - or anyother mods for that matter

i will be fitting my walbro at the same time.

can i do it myself - if not where can i get 1
thanks

 

injector adaptors

Carl Davey, specialist Subaru Impreza parts supply

How to change fuel pump

http://www.jollygreenmonster.com/fuel_pump.asp.htm

 

to the rescue again mate

cheers for that.

 

just had my v1 sti converted to parallel fuel lines,you'll also need the matching injector end cap's and the v1's won't fit v2 injectors.

 

P1 injectors into my phase 1 STi using the kit from Zen.

Subaru Fuel System Products - ZEN Performance

Injector adaptor kit to fit phase 2 injectors to phase 1 rails

Allows injectors designed to fit phase 2 Subaru rails to be fitted into earlier 93-98 Impreza and Legacy.

 

You will need a remap after fitting though, if you dont have a mappable ecu then add that cost onto it also

Tony

 

thanks for all the comments

yeah its going to be going in to get mapped also -ive got a few bits to put on it then get it all setup

cheers

 

The 440 injectors will be good for somewhere around 330 bhp without an FPR and a bit over 340 bhp with an uplift in fuel pressure. This is what they are capable of but not necessarily what your engine will produce.
As already indicated above you need injector adaptors to fit P1 or STi 6 injectors to a version 1.