Right i've been a bit lazy fitting the sensors for my Propsort stepper gauges but a little while ago i printed the guide off here and got on with doing it...

I did the Oil pressure sensor first but i've used the bung under the intercooler instead of the one by the alternator

I turned the car over etc and although the reading was a bit erratic at first after it calmed down it reads fine and still does now! Now can i use the other bung for the Oil Temp sensor or am i going to have to swap them around?

Here's the guide for reference...

https://www.scoobynet.com/interior-1...ure-boost.html

It's an MY00 UK btw

 

Personally i kept my pressure switch where the oe switch was and temp sender on the bung on number 3 cylinder due to that one being the one that seems to fail more freq than not ? Only take 10 min to swap em over